v1.1 Bugs

[jonnerd154]

• Footprint issue: Slider Pot mech pins reversed L/R. Electrical pins are okay.
• Slider Pots upside down: fixed iin firmware
• USB Connector too far from PCB edge: mech interference
• R1, C1, C2 too close together
• Solder jumpers in wrong place: need pogopins to remain connected, but disconnect non-ICSP peripherals
• Can we support both the QFN and SOIC packages simultaneously with overlapping footprints?
• Footprint issue: USB connector slots not cut, fab'd with only the two finishing drills per slot, but not routed between them

Potential CAM file issue: Not yet sure of the cause: Potentially a bad CAM file, CAM file not loadedloaded when generating gerbers, or fab issue. @jonnerd154 to investigate root cause.

• Copper pour relief from board edge and different signals is very tight: relax those spacings (20 mil?).

[jonnerd154]

Also consider adding 3x AAA batteries as an option. USB can remain as optional source. Add "power multiplexer" with P-FET and a schottky to prevent charging/back-powering if two sources are connected simultaneously.

Edit: potential option - https://www.digikey.com/en/products/detail/keystone-electronics/2479/303824