Hello Lee,
great project here.
Thank you in advance for your attention.
I have tested v 0.1.11 with my SunSDR2dx (ESDR3 v 1.3.1)
Diddle_0.1.11_x64_en-US.msi work correct, I install it on WIN11x64
Diddle_0.1.11_x64-setup.exe don't work....error during installation
Well, after several attempts, I’ve managed to correctly decode RTTY signals using my SunSDR2 DX via TCI.
The problem is with transmission: when I send a macro, the radio switches to TX properly,
But no audio stream is output.
What am I doing wrong?
Is there something I need to configure that I’m overlooking?
I look forward to any suggestions, or if you also own a SunSDR tips on the configuration.
TX and RX TAB (Offset - Filter - Taps)
73 de IK2XDE Andrea
ik2xde@gmail.com
Hello Lee,
great project here.
Thank you in advance for your attention.
I have tested v 0.1.11 with my SunSDR2dx (ESDR3 v 1.3.1)
Diddle_0.1.11_x64_en-US.msi work correct, I install it on WIN11x64
Diddle_0.1.11_x64-setup.exe don't work....error during installation
Well, after several attempts, I’ve managed to correctly decode RTTY signals using my SunSDR2 DX via TCI.
The problem is with transmission: when I send a macro, the radio switches to TX properly,
But no audio stream is output.
What am I doing wrong?
Is there something I need to configure that I’m overlooking?
I look forward to any suggestions, or if you also own a SunSDR tips on the configuration.
TX and RX TAB (Offset - Filter - Taps)
73 de IK2XDE Andrea
ik2xde@gmail.com